Lexmark X2470 - Removing and Reinstalling the Software

Power light blinks Solutions
Fast There is a paper jam in the printer.
• To automatically eject the paper:
1 Press and hold .
2 Remove the paper from the paper exit tray.
• To manually remove the paper:
1 Press to turn off the printer.
2 Firmly grasp the paper, and gently pull it out.
3 Press to turn the printer back on.
Once, pauses, and blinks
again
• Raise the scanner unit, and remove any objects blocking the path of the
cartridge carrier.
• The print cartridge is missing or is not installed properly. For more information,
see “Installing a print cartridge” on page 42.
• Check to make sure that the print cartridge is the correct type for the printer.
For information on the print cartridge part number, see “Ordering supplies” on
page 46.
• Reset the printer.
1 Press to turn the printer off.
2 Disconnect the power cord from the wall outlet.
3 Gently remove the power supply from the printer.
4 Reconnect the power supply to the printer.
5 Plug the power cord into the wall outlet.
6 Press to turn the printer on.
• Replace the print cartridge with a new one.
Removing and reinstalling the software
If the printer is not functioning properly, or if a communications error message appears when you try to use the
printer, you may need to remove and reinstall the printer software.
1 Click StartPrograms or All ProgramsLexmark 2400 Series.
2 Select Uninstall.
3 Follow the instructions on the computer screen to remove the printer software.
4 Restart the computer before reinstalling the printer software.
5 Click Cancel on all New Hardware Found screens.
6 Insert the CD, and then follow the instructions on the computer screen to reinstall the software.
61