Lexmark X543 - Page 129

Diagnostic aids 3-3
7525-xxx
Go Back
Previous
Next
INPUT TRAY TESTS (if Tray 2 is installed)
Feed Tests See “Feed Tests” on page 3-17.
Sensor Tests See “Sensor Test” on page 3-17.
BASE SENSOR TEST See “Base Sensor Test” on page 3-18.
Front Door
Input S1
Input S2
Fuser Exit
Standard Bin
C TMC Sensor
M TMC Sensor
Y TMC Sensor
K TMC Sensor
DEVICE TESTS See “Device Tests” on page 3-18.
Flash Test
PRINTER SETUP
Defaults See “Defaults” on page 3-19.
Prt Color Page Count See “Page Counts” on page 3-19.
Prt Mono Page Cnt
Perm Page Count
Serial Number See “Serial Number” on page 3-19.
Engine Setting 1 through 4
Model Name See “Model Name” on page 3-19
Configuration ID See “Configuration ID” on page 3-19
ITU Barcode
Enable Edge to Edge Copy See “Enable Edge to Edge Copy” on page 3-20
Reset Fuser Cnt
EP SETUP
EP Defaults See “EP Defaults” on page 3-21.
Fuser Temp See “Fuser Temp” on page 3-21.
DC Charge Adjust See “DC Charge Adjust, Deve Bias Adj, Transfer Adj” on page 3-21.
Dev Bias Adj See “DC Charge Adjust, Deve Bias Adj, Transfer Adj” on page 3-21.
Transfer Adjust See “DC Charge Adjust, Deve Bias Adj, Transfer Adj” on page 3-21.
TPS SETUP
Right See “Right or Left TPS” on page 3-22.
Left
Reset Color Cal
Cal Ref Adj See “Cal Ref Adj” on page 3-22.
REPORTS
Main Settings Page See “Main Settings Page” on page 3-22.
EVENT LOG
Display Log See “Display Log” on page 3-23.
Diagnostics mode tests (continued)