Lexmark X543 - Toner Meter Cycle (TMC) Card Removal

4-66 Service Manual
7525-xxx
Go Back
Previous
Next
Toner meter cycle (TMC) card removal
1. Remove the right cover. See “Right cover removal” on page 4-7.
2. Remove the waste toner container. See “Waste toner bottle” on page 4-72.
3. Remove the imaging unit (IU). See “Imaging unit (IU) removal” on page 4-45.
4. Remove the rear shield. See “Rear shield removal” on page 4-7.
5. Disconnect and remove the toner meter cycle card cable (A).
Note: Observe the routing for reinstallation.
6. Remove the two plastic screws (B) and the two metal screws (C), and remove the card.