Lexmark X543 - Fax Card Removal; Fax Interface Cable

Repair information 4-107
7525-xxx
Go Back
Previous
Next
3. Pull the logo cover away from the op panel bezel cover.
Fax card removal
1. Remove the rear shield. See “Rear shield removal” on page 4-7.
2. Disconnect the fax interface cable from the fax card. See “Fax interface cable” on page 4-107.
3. Remove the three screws (A) which secure the fax card to the standoff on the controller board.
4. Remove the fax card.
Fax interface cable
1. Carefully detach the fax interface cable from the fax card.
2. Carefully detach the fax interface cable from the connector JMOD2 on the controller board.
Note: Save any toroids for use on the new cable.
A