4-94 Service Manual
7525-xxx
Bezel cover
1. Remove the op panel bezel. See “Op panel bezel removal” on page 4-105.
2. Remove the two screws (A) securing the bezel cover to the top of the op panel mounting frame.
3. Remove the AIO link. See “AIO link” on page 4-101.
4. Lift the flatbed unit to a 45 degree angle. Be careful to avoid damaging or disconnecting the CCD ribbon
cable on the rear of the flatbed.
5. While holding the flatbed in place, remove the three screws (B) securing the bezel cover to the op panel
mounting frame and flatbed.
To Next Page
Loading...
