Diagnostic aids 3-37
7525-xxx
Font Sharpening
This setting is used to set a text point size value below which the high frequency screens will be used when
printing data. This setting affects only PCL, PostScript and PDF emulators.
Settings are in the range of 0–150 (24 is the default). For example, if the value is set to 24, then all fonts sized 24
points or less use the high frequency screens.
To adjust the Font Sharpening setting, perform the following steps:
1. In the configuration menu, scroll to the Font Sharpening menu item and press .
2. Use the or to increase or decrease the settings value. pressing decreases the value and
pressing increases the value.
3. press to accept the setting.
Pel Blurring
The Pel Blurring setting is used if step artifacts are noticed by the customer on copies and scans. When set to
On, Pel Blurring smooths out the artifacts to produce a higher quality image.
To change the setting, perform the following steps:
1. In the Configuration menu, use the arrow keys to scroll to the Pel Blurring menu item.
2. press .
3. press or to select the desired setting.
4. press to accept the change.
5. press to exit the Pel Blurring menu item.
6. Scroll to Exit Config menu.
7. press . The device restarts.
Exit Config Menu
With the Exit Config menu item displayed, press Select ( ) to exit the Configuration Menu. The printer
performs a power-on reset and returns to normal mode.
To Next Page
Loading...
