Lexmark X940E - Common Variables for PCL Emulation

PJL
3-40
Common Variables for PCL Emulation
Note: The word common applies to those variables common to both your printer
and the Hewlett-Packard Company’s LaserJet printers.
Use these variables only for PCL emulation. The
[command modifier:value]
parameter should be specified as
LPARM:PCL. For example:
@PJL SET LPARM:PCL FONTSOURCE=I<CR><LF>
To determine which variables your printer supports, see “Table B-3: Common
Variables for PCL Emulation” on page B-11.
Table 3-5: Common Variables for PCL Emulation
Variable Function Selections Factory Default
FONTNUMBER Font Number 0, 1, .... n 0
FONTSOURCE Font Source I, S, M1, M2, M3, M4, D1
I Internal font source
S Permanent download fonts
M1, M2,
M3, M4 Flash font source
D1 Disk font source
All other values default to internal font source.
I
PITCH Default pitch
(fixed-pitch fonts)
0.08 to 100 (in increments of 0.01)
Note: If an invalid pitch is requested, the printer
selects the closest pitch.
10.00
PTSIZE Default point size
(proportional
spaced fonts)
1 to 1008 (in increments of 0.25)
Note: If an invalid point size is requested, the
printer selects the closest point size.
12.00
SYMSET Symbol set for the
default font
If a symbol set is requested that is not resident
in the printer, the symbol set is not changed.
PC8, PC850
(Country specific)