PJL
3-43
Common Variables for PostScript Emulation
Note: The word common applies to those variables common to both your printer
and the Hewlett-Packard Company’s LaserJet printers.
Use these variables only for PostScript emulation. The
[command modifier:value]
parameter should be specified as
LPARM:POSTSCRIPT. For example:
@PJL SET LPARM:POSTSCRIPT JAMRECOVERY=OFF[<CR>]<LF>
To determine which variables your printer supports, see “Table B-5: Common
Variables for PostScript Emulation” on page B-12.
Table 3-7: Common Variables for PostScript Emulation
Variable Function Selections
Factory
Default
JAMRECOVERY Jam Recovery ON, OFF
For queries, when the Jam Recovery setting is set
to Auto, PJL returns the value of OFF. The
remaining two Jam Recovery values, On and Off
are returned by PJL as ON and OFF respectively.
When PJL is used to set Jam Recovery OFF, the
setting is actually set to Auto. When PJL is used to
set Jam Recovery ON, the setting is set to ON.
Changing this variable also affects PCL emulation.
OFF
PRTPSERRS Print PS Errors ON, OFF OFF
To Next Page
Loading...
