Lexmark X940E - Page 328

PCL Support
A-4
ESC
)s#B Secondary Font Stroke Weight 2-62 ✘✘
ESC
)s#H Secondary Font Pitch 2-61 ✘✘
ESC
)s#P Secondary Font Spacing 2-61 ✘✘
ESC
)s#S Secondary Font Style 2-61 ✘✘
ESC
)s#T Secondary Font Typeface Selection 2-62 ✘✘
ESC
)s#V Secondary Font Height (Point Size) 2-61 ✘✘
ESC
)s#W[data] Load Font Header 2-64 ✓✓
ESC
*b#M Set Raster Compression Mode 2-69 ✓✓
ESC
*b#V[data] Transfer Raster Data (by Plane) 2-68 ✓✓
ESC
*b#W[data] Transfer Raster Data (by Row / Block) 2-69 ✓✓
ESC
*b#Y Y Offset 2-68 ✓✓
ESC
*c#A Horizontal Rectangle Size (in PCL Units) 2-66 ✓✓
ESC
*c#B Vertical Rectangle Size (in PCL Units) 2-66 ✓✓
ESC
*c#D Set Font ID 2-64 ✓✓
ESC
*c#E Set Character Code 2-64 ✓✓
ESC
*c#F Font Control 2-64 ✓✓
ESC
*c#G Area Fill ID 2-65 ✓✓
ESC
*c#H Horizontal Rectangle Size (in Decipoints) 2-66 ✓✓
ESC
*c#K GL/2 Horizontal Plot Size (in Inches) 2-74 ✓✓
ESC
*c#L GL/2 Vertical Plot Size (in Inches) 2-74 ✓✓
ESC
*c#P Fill Rectangular Area 2-67 ✓✓
ESC
*c#Q Pattern Control 2-66 ✓✓
ESC
*c#R Symbol Set ID Code 2-63 ✓✓
ESC
*c#S Symbol Set Control 2-63 ✓✓
ESC
*c0T Set Picture Frame Anchor Point 2-74 ✓✓
ESC
*c#V Vertical Rectangle Size (in Decipoints) 2-66 ✓✓
ESC
*c#W[data] User-Defined Pattern 2-66 ✓✓
Table A-1: PCL Emulation Commands (Continued)
✓ Supported
✘ Not Supported
Page numbers reference command descriptions; however, certain printers may not
support some commands described in the referenced chapter. Previous Lexmark
printers may have supported the command, so the description is retained in the
chapter. If no page number is listed for a command name in the table, then no Lexmark
printer supports the command.
Printer Model
Command Function Page
C935dn,
C935dtn,
C935dttn,
C935hdn
X940e,
X945e