Lexus 2016 IS 200t - Programming a Rolling Code System; Reprogramming a Single Homelink Button

394
6-4. Using the other interior features
IS350/300/200t_U (OM53D18U)
 Programming a rolling code system
Locate the “Learn” or “Smart”
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by man-
ufacturer. Please refer to the opera-
tor’s manual supplied with the garage
door opener motor for details.
Press and release the “Learn” or
“Smart” button.
Perform within 30 seconds
after performing .
Press and hold the programmed
HomeLink
®
button (located
inside the vehicle) for 2 seconds
and release it. Repeat this
sequence (press/hold/release)
up to 3 times to complete pro-
gramming.
If the garage door opener motor
activates when the HomeLink
®
but-
ton is pressed, the garage door
opener motor recognizes the
HomeLink
®
signal.
Repeat the steps above to program another device for any of the remaining
HomeLink
®
buttons.
■ Reprogramming a single HomeLink
®
button
When the following procedure is performed, buttons which already have
devices registered to them can be overwritten:
With one hand, press and hold the desired HomeLink
®
button.
When the HomeLink
®
indicator starts flashing, continue to hold the
HomeLink
®
button and perform “Programming HomeLink
®
” from (it
takes 20 seconds for the HomeLink
®
indicator to start flashing).
4
5
6
5
6
7
1
2
1