159
3-5. Opening, closing the windows and moon roof
3
Operation of each component
NX200t_U_OM78006U
■ The power windows can be operated when
The engine switch is in IGNITION ON mode.
■ Operating the power windows after turning the engine off
The power windows can be operated for approximately 45 seconds even after the
engine switch is turned to ACCESSORY mode or turned off. They cannot, however, be
operated once either front door is opened.
■ Up jam protection function
If an object becomes caught between the window and the window frame, window travel
is stopped and the window is opened slightly.
■ Down jam protection function
When the window is opening, if a foreign object malfunction within the door causes it to
be clamped, the operation stops.
■ When opening and closing the window can not be done
When the up or down jam protection function operates unusually or the door window
can not be fully opened and closed, perform the following operations with the power
window switch of that door.
● Stop the vehicle, with the engine switch in IGNITION ON mode, continually operate
the power window switch in the one-touch closing position within 4 seconds after the
up jam or down jam protection function was activated. Otherwise, by continually oper-
ating the power window switch in the one-touch opening position, the door window can
be opened and closed.
● If the door window can not be opened and closed even when performing the above
operations, implement the following procedure for function initialization.
Turn the engine switch to IGNITION ON mode.
Pull and hold the power window switch in the one-touch closing position and com-
pletely close the door window.
Release the power window switch for a moment and then resume pulling and hold-
ing the switch in the one-touch closing position for approximately 4 seconds.
Press and hold the power window switch in the one-touch opening position and
after the door window is completely opened, continue holding the switch for a fur-
ther 1 second or more.
Pull and hold the power window switch in the one-touch closing position, once
more, and after the door window is completely closed, continue holding the switch
for a further 1 second or more.
If you release the switch while the window is moving, start again from the beginning.
If the window movement does not reverse and can not be closed or completely open,
have the vehicle inspected by your Lexus dealer.
■ Door lock linked window operation
● The power windows can be opened and closed using the mechanical key.* (P. 578)
● The power windows can be opened using the wireless remote control.* (P. 114)
*: These settings must be customized at your Lexus dealer.
1
2
3
To Next Page
Loading...
