Lexus NX200t - Programming the Homelink

457
6-4. Other interior features
6
Interior features
NX200t_U_OM78006U
■ Programming the HomeLink
®
Press and release the HomeLink
®
button you want to program and check
that the HomeLink
®
indicator light flashes orange.
Per fo rm within 60 seconds of , or the indicator light will stop flashing and
programming will not be able to be completed.
Point the remote control transmit-
ter for the device at the rear view
mirror, 1 to 3 in. (25 to 75 mm)
from the HomeLink
®
buttons.
Keep the HomeLink
®
indicator light
in view while programming.
 For U.S.A. owners
Press and hold the handheld
transmitter button until the
HomeLink
®
indicator light
changes from slowly flashing
orange to rapidly flashing green
(rolling code) or continuously lit
green (fixed code), then release
the button.
 Programming an entry gate (for U.S.A. owners)/Programming a device in
the Canadian market
Press and release the remote control transmitter button at 2 second inter-
vals, repeatedly, until the HomeLink
®
indicator light changes from slowly
flashing orange to rapidly flashing green (rolling code) or continuously lit
green (fixed code).
Test the HomeLink
®
operation by pressing the newly programmed button
and observing the indicator light:
● Device with fixed code: If the indicator light is solid/continuous, pro-
gramming has been completed and your garage door or other device
should operate when the HomeLink
®
button is pressed and released.
● Device with rolling code: If the indicator light flashes rapidly, your
garage door opener motor (or other device) is equipped with a rolling
code. Complete the programming process by firmly pressing and hold-
ing the programmed HomeLink
®
button for 2 seconds and then release
the button.
1
3 1
2
3
3
4