Lexus NX200t - After Replacing the Bulbs; Condensation Build-Up on the Inside of the Lens; LED Lights; Replacing the Following Bulbs

537
7-3. Do-it-yourself maintenance
7
Maintenance and care
NX200t_U_OM78006U
■ Replacing the following bulbs
If any of the lights listed below has burnt out, have it replaced by your Lexus
dealer.
● Headlight low beams
● Headlight high beams (LED type)
● Front turn signal lights (LED type)
● Parking lights and Daytime running lights
● Front fog lights
● Cornering lights (if equipped)
● Front side marker lights (LED type)
● Side turn signal lights
● Stop/tail lights
● Rear side marker lights
● High mounted stoplight
● License plate lights
● Outer foot lights
■ After replacing the bulbs
■ LED lights
The headlight low beams, headlight high beams (LED Type), front turn signal lights (LED
Type), parking lights, daytime running lights, front fog lights, cornering lights (if
equipped), front side marker lights (LED Type), side turn signal lights, rear side marker
lights, stop/tail lights, rear side marker lights, high mounted stoplight and license plate
lights, outer foot lights consist of a number of LEDs. If any of the LEDs burn out, take your
vehicle to your Lexus dealer to have the light replaced.
■ Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not indicate a
malfunction. Contact your Lexus dealer for more information in the following situations:
● Large drops of water have built up on the inside of the lens.
● Water has built up inside the headlight.
■ When replacing light bulbs
P. 522
After removing the engine compartment cover,
return the cover to original position with the
clips.
Insert
Press
1
2