LFA TDP 6s - Page 22

To Next Page

To Previous Page

Fill Depth

At times, a tablet will be too small or too large, and its weight must change. Adjusting the ﬁll depth

determines the tablet’s thickness and weight. This can be controlled by changing how high or low

the Lower Punch sits.

Tools and Materials Needed

• Set of metric Allen keys with ball ends

• Crosshead screwdriver

• Disposable latex/rubber gloves (for food grade products and to protect hands from grease)

• Hairnet and/or beard net (food grade products only)

• Sterile shoe covers (food grade products only)

Instructions

Note: Wear latex/rubber gloves (and appropriate food grade attire if applicable) during this

process.

1. Produce a test tablet to determine how the Tooling should be adjusted.

2. Remove the Ejection Tray with a crosshead screwdriver.

WARNING: To prevent any potential personal injury, unplug the TDP 6s

from

the electrical outlet.