LFA TDP 6s - Page 23

To Next Page

To Previous Page

3. Remove the Lower Drift Pin Assembly Locking Bar with an Allen key.

4. Rotate the Lower Cog in the Lower Drift Pin Assembly by hand.

4.1 Note: To increase the tablet weight, turn counterclockwise. To decrease the tablet weight,

turn clockwise.

5. Replace the bar in the Lower Drift Pin Assembly Locking Bar with an Allen key.

5.1 Note: Ensure that the Lower Drift Pin Assembly Locking Bar is situated vertically.

6. Produce a test tablet to make sure the weight is correct.

7. Reattach the Ejection Tray to the TDP 6s