50
Clean the Base
16. Vacuum any powder/debris from the machine.
17. Spray the TDP 6s
®
Base with the cleaner, particularly in the Tooling's location.
18. Rinse the cleaner off with potable water.
19. Sanitize the TDP 6s
®
Base with a clean cloth.
14. Remove the bolt that locks the Lower Punch with an Allen key.
15. Remove the Lower Punch by hand.
15.1 Note: If you cannot remove by hand, carefully use grippers or pliers.
Clean the Parts
20. Take one of the parts removed from the machine and submerge it in the bowl of warm soapy
water.
20.1 Note: To ensure that all dirt and debris are removed, wash one part at a time.
21. Take a clean cloth and carefully wash the part thoroughly.
21.1 Note: Use the toothbrush for difficult-to-remove debris. When cleaning tooling, use
non-abrasive cleaning equipment such as a soft pipe cleaner and soft cloth.
22. Dry part immediately after it is cleaned and rinsed.
23. Sanitize part with a clean cloth.
24. Repeat steps 20-23 for each remaining part until they are all clean.
Note: Before washing the Base Plate, LFA recommends using
our Die Seat Cleaner. You can order the Die Seat Cleaner and
Insertion Ring on our website at https://www.lfatabletpresses.com/
die-seat-cleaner-insertion-ring
To Next Page
Loading...