LFA TDP 6s - Page 51

51
Cleaning Schedule Matrix
Part
Frequency
After installing
machine
After every use Before every
use
In between prod-
ucts that present
a cross contami-
nation risk
Weekly Monthly Before placing In
storage
After removing
from storage
Ejection Tray
Remove from machine Remove from machine Install on machine Remove from machine N/A N/A Remove from machine Install on machine
Tooling
Remove from machine Remove from machine Install into machine Remove from machine N/A N/A Remove from machine Install on machine
Boot
Remove from machine Remove from machine Install into machine Remove from machine N/A N/A Remove from machine Install on machine
Base Plate
Remove from machine Remove from machine Install on machine Remove from machine N/A N/A Remove from machine Install on machine
Hopper
Remove from machine Remove from machine Install on machine Remove from machine N/A N/A Remove from machine Install on machine
Top Cam area
Clean in machine Clean in machine Clean in machine Clean in machine Clean in machine Clean in machine Clean in machine Clean in machine
Upper Drift Pin Assembly
Remove from machine Remove from machine Remove from
machine
Remove from machine Remove from
machine
Remove from machine Remove from machine Remove from machine
Motor
Clean on machine Clean in machine Clean in machine N/A Clean on machine Clean in machine Clean on machine Clean on machine
Upper Drift Pin Assembly
Threaded Cam
Clean in machine Clean in machine Clean in machine Clean in machine Clean in machine Clean in machine Clean in machine Clean in machine
Lower Drift Pin Assembly
Remove from machine Remove from machine Remove from
machine
Remove from machine Remove from
machine
Remove from machine Remove from machine Remove from machine
Electrical Drive Flywheel
Clean on machine Clean in machine Clean in machine Clean in machine N/A Clean on machine Clean on machine Clean on machine
Base/Frame
Clean on machine Clean in machine Remove from
machine
Remove from machine N/A N/A Clean in machine Clean on machine
Cleaning Level Key
Level 1 - Remove powder
Level 2 - Dry clean with cloth
Level 3 - Dry clean and re-lubricate if specified in lubrication schedule
Level 4 - Wet clean and re-lubricate if specified in lubrication schedule
Remove from machine - Take part out of machine and clean if required. Store it correctly or install back into machine.
Install into machine - Install part into the machine and make sure that it has been cleaned. If needed, lubricate to the level required.
Clean on/in machine - Clean the part while in the machine and do not remove it. Make sure that all contact surfaces are clean to the level required.
This cleaning matrix is intended as a guide only and is not an exhaustive list. All cleaning schedules will need to be adapted to the industry and product, following industry regulations and the material safety data sheets that come with
specific products. Please check with your Food Safety Manager/Department, Quality Control Manager/Department, or other relevant internal departments at your company before using.