LFA TDP 6s - Page 56

56
Boot Bolt and Spring (#AEC0051)
The Boot Bolt and Spring holds the Boot in place
while the press is running and allows it to move
back and forth. It is kept secure with the set
screw on the side of the Boot. Order at https://
www.lfatabletpresses.com/tdp6s-boot-bolt-spring
Boot (#AEC0036)
The Boot is where the dry granular materials
are held for pressing. It fills the Die bore with
the dry granular material and moves the finished
tablet out of the Die before refilling it with the
next batch of materials. Order at https://www.
lfatabletpresses.com/tdp6s-boot
Upper Drift Pin Assembly (#AFC0002)
The Upper Drift Pin Assembly holds the Upper
Punch in place. It is attached to the Eccentric
Sheave. Order at https://www.lfatabletpresses.
com/tdp6s-upper-drift-pin-assembly
Hopper (#AEC0030)
The Hopper is the funnel that holds the granular
materials before it moves into the Boot to be
pressed. Order at https://www.lfatabletpresses.
com/tdp6s-hopper
Eccentric Sheave Inner Strap (#AFC0032)
The Eccentric Sheave Inner Strap attaches the
Upper Drift Pin Assembly to the Top Cam Drive
Shaft. Order at https://www.lfatabletpresses.com/
tdp6s-eccentric-inner-sheave-strap