Location and function of controls
12. INPUT SELECT
selects the remote operating mode.
switches the set on from standby.
13. I/II
selects the language during dual language broadcast.
selects the sound output.
14. TELETEXT BUTTONS
These buttons are used for teletext.
For further details, see the ‘Teletext’ section.
15. MUTE
switches the sound on or off.
16. SSM (Sound Status Memory)
recalls your preferred sound setting.
17. LIST
displays the programme table.
18. SLEEP
sets the sleep timer.
19. ZOOM+ / ZOOM-
Enlarges or reduces the main picture size.
Note : In teletext mode, the PR +/-, SWAP and PIP INPUT buttons
are used for teletext function.
Battery installation
The remote control handset is powered by two AAA type batteries.
To load the batteries, turn the remote control handset over and
open the battery compartment. Install two batteries as indicated by
the polarity symbols ( and ) marked inside the compartment.
Note : To avoid damage from possible battery leakage, remove the
batteries if you do not plan to use the remote control handset for an
extended period of time.
5
+
-
To Next Page
