Adjust the settings - more you can do
Adjust the language settings
OSD – Select a language for the Setup menu and on-screen display.
In case there is displayed as “-” or other error mark on display when
you change OSD, do as follows;
- Restart the unit
- Change function
- Disconnect and connect USB device.
Disc Menu/Audio/Subtitle – Select a language for the Menu/Audio/Subtitle.
[Original]: Refers to the original language in which the disc was recorded.
[Others]: To select another language, press number buttons then ENTER to
enter the corresponding 4-digit number according to the language code list in
the reference chapter (see page 16). If you make a mistake before pressing
ENTER, press CLEAR.
[OFF] (for Disc Subtitle): Turn off Subtitle.
Adjust the display settings
TV Aspect – Select which screen aspect to use based on the shape of your TV screen.
[4:3]: Select when a standard 4:3 TV is connected.
[16:9]: Select when a 16:9 wide TV is connected.
Display Mode – If you selected 4:3, you’ll need to define how you would like
widescreen programs and films to be displayed on your TV screen.
[Letterbox]: This displays a widescreen picture with black bands at the top
and bottom of the screen.
[Panscan]: This fills the entire 4:3 screen, cropping the picture as necessary.
TV Output Select – Select an option according to the TV connection type.
[YPbPr]: When your TV is connected with the COMPONENT/PROGRES-
SIVE SCAN jacks on the unit.
[RGB]: When your TV is connected with the SCART jack.
If you change TV Output Select to RGB from YPbPr on the setup menu
especially when connecting the unit in the way of component video connection,
the screen turns black. In that case, connect the video cable to MONITOR jack
and select YPbPr on the setup menu again.
Progressive Scan (For Component Video connections) – Selects whether
the COMPONENT/PROGRESSIVE SCAN OUTPUT jacks output progressive
signal. If your TV accepts progressive format signals, you will enjoy accurate
color reproduction and high quality image by selecting [ON]. If your TV does not
accept progressive format signals, select [OFF].
If you set Progressive Scan to [On] in error, you must reset the unit. First,
remove the disc in the unit. Next, press and hold STOP for five seconds. The
video output will be restored to the standard setting, and a picture will be visible
on your TV.
7
Adjust the settings
ON REMOTE
1 Display setup menu : SETUP
2Select a desired option on the first level:
vv VV
3 Move to second level:
BB
4 Select a desired option on the second level:
vv VV
5 Move to third level:
BB
6 Change the setting:
vv VV
, ENTER
Initial Setting the Area Code
1Display setup menu: SETUP
2Select LOCK menu on the first level: v V
3 Move to second level:
Appears the activated Area code on the
second level.: B
4 Move to third level: B
5Enter the new password: numerical buttons
(0-9) and ENTER
6 Recheck entered new password:
numerical buttons
(0-9) and ENTER
7 Select a code for a geographic area:
After select,Rating and Password will be
vV b B
activated.(page 16)
8To confirm, press:
Make sure to finish setting the Area Code ENTER
before leaving the setup menu If you cannot
set the Rating and password.
After factory setting ,To set the Area code you have to as below.
ON REMOTE
To Next Page
Loading...
