7 Chapter 3
Machine Disassembly and Replacement
This section provides disassembly procedures for RD-JS31 DLP Projector. Before you begin
any of these procedures, be sure to turn off the power, computer system, and other attached
devices; then disconnect the power cable from the electronically outlet. Moreover, when you
disassemble the projector, be sure to put the screws in a safe place and separate them accord-
ing to grouping.
Tool Needed
Chapter
Item PHOTO
Long Nose Nipper
Hex Sleeves 5mm
Screw Bit (+) : 107
Screw Bit (+) : 101
Screw Bit (+) : 102
To Next Page
Loading...
Need help?
General
