20 Section 2A: Your Phone: The Basics
Turning Your Phone On and Off
Turning Your Phone On
To turn your phone on:
©
Press and hold for approximately two seconds.
Once your phone is on, it may display “Searching for Service”,
which indicates that your phone is searching for a signal.
When your phone finds a signal, it automatically enters
standby mode – the phone’s idle state. At this point, you are
ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of
searching, a Power Save feature is automatically activated.
When a signal is found, your phone automatically returns to
standby mode.
In Power Save mode, your phone searches for a signal
periodically without your intervention. You can also initiate a
search for service by pressing any key (when your phone is
turned on).
Tip: The Power Save feature helps to conserve your battery power when
you are in an area where there is no signal.
To Next Page
Loading...
