17
OPERATION SETTING
ENGLISH
Cooling operation
Cooling operation’s minimum setting temperature is 5°C.
• The desired temperature can be controlled in the units of 1°C.
- Set the desired temperature lower than the water temperature.
- water temperature is displayed on the default screen of the remote controller.
- If the setpoint is set higher than the water temperature, then the unit will remain in the cool
mode but will not begin to cool the water temperature exceeds the setpoint.
- If your unit is operating in cooling mode and you press the [On/Off] button the cooling operation
will shut off.
NOTE
!
The compressor starts after 3 minutes and the cold wind comes out.
In the cooling operation, you can select the desired temperature in the range of 5°C ~ 27°C.
The favorable temperature difference between the water inlet temperature and outlet
temperature is 5°C.
What is 3 minute delay function?
After the cooling stops, when the product is started right away, the reason that the cold
water does not come out is that it is the function to protect the compressor.
The compressor starts after 3 minutes and the cold wind comes out.
To Next Page
Loading...
Need help?
General