39
FUNCTION SETTING
ENGLISH
Low Noise Mode Time setting
It is the function to set the start and end time of the outdoor unit’s low noise mode operation.
• In the function setting list, select the Low Noise Mode Time category, and press [OK] button to
move to the detail screen.
- After setting the start time and the end time, press [OK] button to move to the upper level
list.
- If the start time and the current time are the same, it enters the outdoor unit low noise
operation mode, and in the monitoring screen, ‘in outdoor unit low noise operation mode’
message is displayed.
- If the end time and the current time are the same, the outdoor unit low noise operation mode
is cleared.
NOTE
!
Low noise mode time setting function can be set only when the installer setting’s outdoor
unit function M/S setting is set to “Master”.
Low noise mode time setting function is only available in some products.
CAUTION
If the function is not used, please set it to Off.
When you enter the low noise operation, the cooling capacity may be degraded.
!
To Next Page
Loading...
Need help?
General