BUTTON FUNCTIONS – Roboking 2.0
• Use the TIMER button to start cleaning after a set amount of time has elapsed.
• The timer can be set from 1 to maximum of 12 hours in 1 hour units.
• If the timer is set whilst the unit is away from the home station, the cleaning
time will be reduced. Therefore use the product while attached to the home
station as much as possible.
• The timer setting is inoperative if there is no dust bin.
• Press this button to change the cleaning mode.
• When the product is attached to the home station and when the timer is set,
spot cleaning mode cannot be selected.
TIMER
MODE
HOMING
START/STOP
• Press the START/STOP button to turn the Roboking 2.0 on/off or start/stop
cleaning.
• Press the START/STOP button while the Roboking 2.0 is on and it will
automatically start cleaning.
• If the START/STOP button is pressed during automatic cleaning, the Roboking 2.0
will stop cleaning.
• Press and hold the START/STOP button for approximately two seconds to turn
off the Roboking 2.0.
• If the button is pressed while in the timer mode, the reservation will be canceled.
• Press the HOMING button to move the Roboking 2.0 to the home station for
battery charging.
• When cleaning is complete or the battery is low, the device will automatically
move to the home station to charge the battery even without pressing the
HOMING button.
To Next Page
Loading...
Need help?
General
