HOW TO INSTALL THE HOME STATION
1. Position the home station against a wall, to prevent sliding during
docking, on hard level flooring.
Remove objects within 1m to the right and left side and within
2m to the front.
2. Plug the power cord into an outlet.
Wrap the power cord around the fixed hook on the back side of
the home station or along the wall surface so that the travel path
of the Roboking 2.0 will not be obstructed.
3. Fix the home station against the wall so that it does not move.
4. When the remote controller is not used, store it on the remote
controller holder on the home station.
Fixing hook of power cord
• Always keep the home station plugged in. If the home station is not plugged in, the
Roboking 2.0 will not return to the station to charge automatically.
How to Install the Home Station
< Warning > Do not operate the Roboking 2.0 or its Home Station if it has a damaged cord or plug,
if it is not working properly, or if it has been damaged or dropped. To avoid hazard, the
cord must be replaced by LG Electronics, Inc. or a qualified service person.
Tip
To Next Page
Loading...
Need help?
General
