CLEANING THE SENSOR/CHARGING TERMINAL
Receiving sensor of
remote controller
Camera sensor
• Do not clean the Roboking 2.0 by directly spraying it with water, thinner, benzene, etc.
• Call the service center if the sensor or charging terminal is damaged. Sensor and terminal
damage can cause the product to malfunction.
There are sensors on the Roboking 2.0 that can detect obstacles, stairways
and the home station for charging the battery. In order to maintain the
performance of the Roboking 2.0, regularly clean the sensors and charging
terminal as follows:
1. Lay a smooth cloth on the floor, overturn the Roboking 2.0 and put it on
the cloth.
※
Please make sure to remove the dust bin before turning over the main body.
Otherwise, the dust in the dust bin may fall out.
2. Turn off the power switch on the bottom of the Roboking 2.0. Injury can
be caused by the activation of the Roboking 2.0 if the main power is not
turned off.
3. Use a smooth cloth or cleaning brush to wipe the dust off each sensor
and the charging terminal as described below.
Charging terminal
Obstacle detection sensor
Cliff detection sensor
Charging terminal
Bottom camera sensor
Lens
Tip
※
The device may move backwards while operating when the cliff sensor or bottom camera sensor is
contaminated.
Please clean the sensor with soft brush or cleaning brush.
To Next Page
Loading...
Need help?
General
