LOCATION SEARCH FUNCTION
When the user removes any abnormal condition of
Roboking 2.0 or moves the location arbitrarily, the
location search function will activate.
1. Locate Roboking 2.0 near the location where
Roboking 2.0 was moved.
※
Location search is more effective when
Roboking 2.0 is closer to the location where it
was moved.
※
If it goes out of diameter of 1m from the
occurrence position, it becomes difficult to
search the position.
2. Press the START/STOP button on Roboking 2.0 or START button on the remote controller.
Roboking 2.0 will start the location search function along with an audio guide.
※
When the location search is successfully completed, Roboking 2.0 will continue to the cleaning from where
it was moved. If position search fails, it will start again from the beginning.
Roboking 2.0 remembers its location while cleaning.
If the user moves the Roboking 2.0 while it is operating, it will search its location with
the location search function so that it can continue from the previous location.
Change location
Location of incident
Location of incident
1m
1m
When the location search
function is activated, the
cleaning mode of the status
indicator will flash
Checking current location.
• When the power is turned off after the location search function is set, the location search
function will be canceled.
• Location search is more effective when Roboking 2.0 is closer to the location where it was
moved.
• The position search function will be cancelled if the remote is pressed to engage any other
function.
Tip
To Next Page
Loading...
Need help?
General
