CLEANING THE DUST BIN
1. Open the dust bin cover by pressing the PUSH
button on the Roboking 2.0.
2. Grab the handle of the dust bin and pull it
upward.
3. Separate the HEPA filter and the inside sponge
filter by removing the HEPA filter
※
To clean the dust bin filter, refer to page 24.
4. Lift the cover upward while pressing the
separation button on the dust bin.
5. Empty the dust bin and clean it with a cleaning
brush or under running water.
※
Please use vacuum cleaner when cleaning the
filter.
(Be sure to fully dry the filter after washing it. It
may can affect inhalation or can make smell.)
6. After cleaning with water, completely dry the dust
bin in a well-ventilated area out of direct sunlight.
7. When you have completed cleaning the dust bin,
close the dust bin lid and replace the sponge
filter and HEPA filter.
8. Put the dust bin into the Roboking 2.0 and close
the dust bin cover.
If the dust bin is full, suction power can be weakened. Clean the dust bin before and after each cleaning
session. Clean the dust bin using the following sequence:
• After cleaning, always mount the dust bin filters (HEPA filter, sponge filter) to the dust bin.
If they are not mounted, dust may enter the Roboking 2.0 interior and cause product failure.
• After cleaning the dust bin, make sure to start the operation with the dust bin installed.
If operation is attempted without the dust bin, a voice message, “please check the dust bin”
will sound.
Tip
To Next Page
Loading...
Need help?
General
