BEFORE YOU START
• Do not use this device in a room where a child is left alone. The child could be injured.
• Remove fragile or unnecessary objects from the room to be cleaned.
Especially, remove expensive ceramics and valuables from the floor.
• Close the cover of the dust bin before cleaning.
• Remove any moisture that might be on the floor.
• Remove cables, strips, towels, mat etc. from the floor so they will not get caught by the brush.
• Confirm whether battery charge is sufficient, and if it is low, recharge it.
• Empty the dust bin if it is full.
• Close the doors of any room that you do not want the Roboking 2.0 to enter. During cleaning,
the Roboking 2.0 may enter another room and continue cleaning.
• When the mop is attached, Roboking 2.0 will not be able to go over thresholds of 5mm or higher.
If you are not planning to use the mop for cleaning, separate the mop before using Roboking 2.0.
1. Open the battery cover by lifting the rear hook of the remote controller.
2. Insert two AAA batteries, checking for +, - nodes while loading.
3. Close the battery cover completely so that the batteries will not fall out.
• Only press one button at a time.
• Do not drop or subject it to forceful impact.
• Do not store it near devices that give off heat, fire or hot air.
• Certain fluorescent lamps, such as 3 wavelength fluorescent lamps, can interfere with the activation of the
remote control. Therefore, use it as far away as possible from such lamps.
• If the remote control is far from the Roboking 2.0 when activated, it may fail to operate properly. Use the
device within 3 m (9.84 ft) of the Roboking 2.0 if possible.
Check these items before cleaning
Loading the remote controller battery
Precautions while using the remote control
To Next Page
Loading...
Need help?
General
