CLEANING THE DUST BIN FILTER
The dust bin filters are comprised of the HEPA filter and the sponge filter.
Clean the HEPA filter and the sponge filter according to the following sequence:
1. Separate the HEPA filter and the inside sponge
filter by removing the HEPA filter (as shown).
3. After washing the HEPA filter and the sponge filter
with water, place them out of direct sunlight and allow
them to dry completely.
※
Please use vacuum cleaner when cleaning the filter.
(Be sure to fully dry the filter after washing it. It may
can affect inhalation or can make smell.)
4. Mount the cleaned HEPA filter and sponge filter
into the dust bin according to the sequence
shown to the right. When assembling the filter,
the filter handle should face upward.
2. Carefully clean any fine dust off the HEPA filter and
the sponge filter with a vacuum cleaner or water.
• In order to maintain the performance of the Roboking 2.0, the HEPA filter should be cleaned
with a cleaning brush or vacuum cleaner at least once a week, and should be washed under
running water at least once a month.
Tip
To Next Page
Loading...
Need help?
General
