CLEANING MODES
With zigzag cleaning, the total of the cleaning area will be
cleaned with the repetition of zigzag traveling.
If rapid cleaning is desired, use zigzag cleaning.
When pressing ‘ZIGZAG’ button on the remote controller,
zigzag cleaning will be started while zigzag cleaning icon is
indicated by the indication lamp.
With spatial expansion cleaning, the cleaning will be
performed by dividing the cleaning area into partial square
spaces.
If elaborate cleaning is desired, use spatial expansion
cleaning.
When pressing ‘Cell by Cell’ button on the remote
controller, spatial expansion cleaning will be started
while spatial expansion cleaning icon is indicated by the
indication lamp.
The 1st stage:
The maximum outline of 3m x 3m of cleaning area
will be cleaned. (The size of outline will be changed in
accordance with the shape of the house inside.)
The 2nd stage:
Inside of the outline will be cleaned with zigzag traveling.
When the 1st, 2nd stages are completed, the inside of
the cleaning area will be cleaned through the repetition of
above cleaning method as the device is being moved to
the next cleaning area.
• Once set up, the cleaning mode will be kept in memory even after the power supply is
turned off.
• During operation, if a mode change is required, press the STOP button and then select the
mode.
Zigzag Cleaning
Spatial Expansion Cleaning
Tip
To Next Page
Loading...
Need help?
General
