change.
⑤ When the oil filter is filled with hydraulic oil, run
the engine at idle speed, turn the steering wheel left and right
for several times, and at the same time, keep supplementing
oil till the oil level does not lower and is within the range and
no bubble appears.
△
! CAUTION:
The machine as delivered uses L-HM32 hydraulic
oil. The users can change to the L-HM46
hydraulic oil. It is strictly prohibited to
use the two oils mixed.
e. During maintenance, it is required to check the
clearance between moving parts, such as tie rod and
drag link joints. If the clearance is too large, replace
parts immediately. It is also required to add grease to
each grease tap for maintenance.
4) Important connected positions and tightening torque
requirements.
To Next Page
