to the original place, check, and top up.
5) Finally, screw in the oil plug.
△
! WARNING: The oiling and bleeding of tilting
system are not allowed unless the cab is restored.
The low temperature and wear-resistant hydraulic oil of
0.5 L L-HV32 GB11118.1 shall be applied. Before filling,
always check the hydraulic oil for cleanness, and add
some oil if acceptable.
3.5.4 Check tilting system function
1) Tilt the cab forward to TDC, and check if the cab can
fall normally after it exceeds TDC. If the system works
normally, the cab will fall down gradually under
resistance without any obvious impact.
2) After tilted up for about 30º, the cab shall be held at
this position for 20 min without any settlement.
3.6 Preparation before driving
△
! WARNING: Keep a good vehicle condition.
Do not drive in case of any fault!
3.6.1 Preparation
The preparations before driving mainly include: routine
inspection before every driving, engine start and
flameout.
1) Turn on the main power switch (as shown in Fig.
3-25) to power on the truck.
2) Check the working condition of electrical system.
When the key switch is turned on (i.e. key switch is set
to ON), the instrument panels indicate normally.
3) Check oil/coolant condition of the truck.
a. Check hydraulic oil: park the truck on the flat road,
lift the container continuously for 5 times, and then
keep it still for 15min. At this moment, the standard
To Next Page
Loading...
