beneath, the stay bar of the cargo body should be set to a safe
position for support, and restore the stay bar once the repair
is finished.
3) Always inspect the tire from the side and never stay before
or behind the rotating tire.
4) Repair and replacement of tire shall be done by the
specialized personnel as it is highly risky.
5) Be careful when doing welding around the tire, to avoid
accidents due to tire explosion.
6) When welding the truck for repair, always turn off its
power main switch. Do not perform electric welding or flame
cutting to the pipeline containing flammable liquid. Make
sure to clean with non-inflammable liquid before such
operations.
7) Always lower the cargo body to the subframe before
leaving the truck unattended, and check that the lifting
control lever is in the center, the parking brake handle is
applied and the transmission control lever is set to the
NEUTRAL position, and then shut down the engine.
1.4 Notices&signs and their pasting
positions
1) reading instructions: located on the left side of the
cab dashboard
To Next Page
Loading...
