To stop the vehicle, follow the steps below:
1) When the vehicle is running, first release the
accelerator pedal to reduce vehicle speed.
2) When the vehicle approaches the stopping
position, slightly depress the brake pedal to stop the
vehicle slowly.
3) When the vehicle is stopped stable, engage the
transmission in neutral and pull down the parking
brake valve handle to make the vehicle in parking
brake state. When applying the brake, note the
following:
1) When applying the brake, except for emergency
conditions, do not quickly depress the brake pedal
hard to the bottom and keep depressing it, which may
cause personal injury or lead to component damage.
2) Avoid continuously depressing the brake pedal in
a short time and for many times so as to prevent huge
consumption of compressed air in the air reservoir
which will affect the braking performance of vehicle
and lead to the vehicle out of control further.
3) Do not frequently use the service brake; otherwise
it may lead to brake overheat which will significantly
affect brake effect.
4) It is not recommended to use the emergency brake
under non-emergency conditions. Especially when
To Next Page
