Horizontally move the combination switch handle
forward to turn on the right turn signal lamp; and
horizontally move it backward to turn on the left turn
signal lamp.
When the key switch is set to position 3, move the
handle to turn on the turn signal lamp, and then a
prompt will be heard; when the key switch is set to
position 1 and 2, move the handle to turn on the turn
signal lamp, and then a prompt will not be heard.
2) Headlamp operation:
When the combination switch handle is set to
neutral position, key switch to position 3 and rocker
switch to position 2, the low beam or high beam will be
on. At this time, lift the combination switch handle
upward for 4°, and then high beam and low beam will
be both on (applied for instant lighting for overtaking or
meeting); lift the handle for another 10° for dimming
(high beam to low beam or vice versa).
Release the handle, and it will be automatically reset.
During daytime overtaking and meeting, lift the
handle upward for 4°, and the high beam will be on;
release the handle, and it will be automatically reset.
3) Wiper operation
Turn the combination switch to select the required
swing gear for wiper.
Press and hold the windshield washer button, and the
water jet on wiper blade will inject glass cleaner, and
meanwhile, the wiper will automatically start working at
low gear; water injection will be stopped after the
release. The glass cleaner filler port is located inside
the cab left ladderway.
To Next Page
Loading...
