that the vehicle is kept in normal working condition.
Precautions for running-in:
1) Do not speed up immediately after the engine gets
started. Only when the coolant temperature reaches
normal range can the engine speed be increased.
2) During running-in, the vehicle shall travel along a
relatively even road with good condition.
3) Do gearshift in time and engage the clutch
smoothly for the avoidance of sudden acceleration
and emergency brake.
4) Before travelling uphill, engage a low gear in time
in case that engine runs at a too low speed.
5) A new vehicle cannot travel at full speed with full
load. Always monitor the instruments, indicator
lamps and alarm indicators!
6) Check and control the engine oil pressure and
coolant temperature. Monitor the temperature of
transmission, front/rear axles, wheel hub and brake
drum. In case of overheating, find out the cause, and
adjust and repair in time.
7) The vehicle must experience a run-in of 1,500km.
it might be put into use after the brake interval is
readjusted and the fasteners (except gelatinizes bolts)
are rechecked.
At the completion of running-in, check and service
the vehicle according to ―first-class maintenance‖ in
maintenance provisions herein.
To Next Page
Loading...
