speed. To use the engine anti-drag brake control speed, you
need to choose a lower gear, you can make
the engine to produce greater braking force. When the
vehicle load is large, the ramp is steep when the vehicle
needs to be pre-selected in the ramp before the lower gear, if
the speed continues to increase, so that the engine speed
exceeds the limit, the
transmission will automatically rise to the next higher block
Bit. If the speed is too high, use the foot brake or other
deceleration devices (such as retarder) to
slow down the vehicle. In the use of engine braking, in order
to avoid vehicle failure should be combined with the use of
downshift, foot brake, retarder and other slowdown device.
When the speed increases, resulting in the engine speed
exceeds the current gear limit value so that the transmission
upshift, will weaken the engine braking effect, may lead to
speed out of control. So should be timely use of foot brake or
retarder and other braking devices to prevent the engine
speed is too high when the engine speed exceeds the limit.
4)Start at low temperature
In the low temperature start, the transmission fluid needs to
warm, if the temperature below -23 °C , start the engine after
the engine warm up for about 20 minutes.
5)Snow and sediment road running
In the snow and sediment road running, due toreduced road
surface adhesion, high speed or the use of retarders are likely
to cause the wheel slip or out of control, so when driving on
To Next Page
Loading...
