LifeSize Icon Video System Guide 15
3. To zoom, select to activate the feature.
Tap and to zoom in and out. Select again to exit.
NOTE With the zoom feature active, tap to access Pan/Tilt.
4. To end your camera control session, select .
Camera Presets
A camera preset is a predefined camera position that is associated with a numeral. Camera presets enable
you to quickly change the position of a camera during a call.
1. Select the camera you want to control: , , or .
2. Navigate to the presets and select a numeral. A preset might have two available options:
- If a preset shows Select to move, select the preset to adjust the camera position as defined by
the preset.
- If a preset shows Hold to set, select the preset and hold until Preset saved appears. This action
associates the camera’s position with the numeral.
Recording with LifeSize UVC Video Center
With LifeSize UVC Video Center configured in your environment, you can initiate a recording while you are
not in a call.
1. Select .
2. Select from one of the available recording options to start the recording session:
– Record input from the camera.
– Record input from the presentation.
– Record two streams: input from the presentation and camera.
– Record input from both cameras. Select or to select the camera that provides the
primary input. This option is available only with two connected cameras.
3. Select to start recording.
4. If prompted, enter a valid recording key. If successful, the recording begins and the recording icon
appears.
5. Optional: If you are recording input from the camera or from a presentation, select to toggle the
input: presentation or camera. If you are recording two streams, select to toggle between recording
two streams (presentation and camera) and a single stream (camera).
6. To stop recording, select .
7. To end the recording session, select the appropriate option: , , , or , depending on your
selection in step 2.
To Next Page
Loading...
