Lifetime 51544 - Page 25

25
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
1/2”
!!* (x2)
ABD (x2)
!"& (x2)
!"&
!"&
!!*
!"'
ABD
!"&
ALX
Insert two vXv4AP"OLTS!"'with the v7ASHERS!"$ and the
v2UBBER7ASHERS!"&through the bottom holes in the back of the Rim
(ALX) as shown, and secure the hardware with two v(EX4.UTS!!*.
SEC
3.3
Note: Do not overtighten the hardware so that the 7/16” Rubber
Washers bulge outward as shown.
!
Note: Make sure that the 5/16” x 2 1/2” Tap Bolts are
positioned on the outside edge of the holes as shown.
!
Correct
Incorrect
!"'
!"'
!!*
!!*
ALX
!"' (x2)