Lifetime 51544 - Filling with Sand

45
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
(362 lb)
./(!2$7!2%2%15)2%$&/24()30!'%
SEC
6.3
4WOADULTSAREREQUIREDTOCOMPLETEASSEMBLY4OPREVENTSERIOUSINJURIESTHE
0OLESHOULDBEHELDDOWNBYONEADULTATALLTIMESWHILETHE"ASEISBEINGlLLED
/04)/.!&),,).'7)4(3!.$
(362 lb of sand required)
a. Insert a "ASE0LUG!%& into the "ASE!*- in the hole closest to the Pole.
b. Using a funnel, fi ll the Base with sand through the hole furthest from
the Pole until the sand is just below the hole.
c. Using two adults, stand the Base up on a fl at surface and fi nish fi lling
the Base with sand.
d. Insert the other Base Plug into the hole furthest from the Pole.
7!2.).'
For safety reasons, we recommend that sand be used
instead of water to fi ll the Base. If a leak develops, water
could run out unnoticed, allowing the system to fall over,
resulting in serious personal injuries, or property damage.
If using Water, check the Base carefully for leaks. If a
leak is found, lay the system down on the ground and
call Customer Service. Do not use, stand up, or play on
a leaking system.
!%&
!*-