MMX8x4-HT series – User's Manual 103
General LW2 Commands
{i}
{S}
{f}
Connection Test
{PING}
Compile Time
{CT}
{IS}
{FC}
Restart the Matrix Router
{RST}
{ST}
Restore Factory Default Settings
Port and Crosspoint Settings
Switch One Input to One Output
{<in>@<out>•<layer>}
Switch One Input to All Output
{<in>@O}
{#<out>•<layer>}
{+<out>•<layer>}
{#><out>•<layer>}
Unlock the Output
{+<<out>•<layer>}
<layer>}
<layer>}
Batch Switch Outputs
Set the IP Address
<type>;<ip_address>}
Set the Subnet Mask
<subnet_mask>}
Set the Gateway Address
<gateway_addr>}
Apply Network Settings
{ip_apply}
GPIO Settings
Set GPIO State
{GPIO<port_nr><direction>;<output_level>}
Relay Settings
Set Relay Connection State
<port_nr><direction>;<state>}
To Next Page
Loading...
