Lightware VINX-110-HDMI-DEC - Software Control Modes

 VINX-1x0-HDMI Extenders – User's Manual 37

5.1. Software Control Modes
The VINX device can be controlled by the following ways:
▪ Using the built-in web page,
▪ Using the Lightware Device Controller (LDC) software, or
▪ Sending LW3 commands (detailed in the Programmer's
Reference chapter).
Built-in web page vs. LDC

there are some minor differences:
Function Built-in Web LDC
Platform

Google Chrome

mac OS
Installation

needed only
Required
Firmware upgrade

-
Device discovery -

ATTENTION!  

the changes only if the program is also updated.
INFO:         
contains screenshots using the built-in web page.
The Main window – displayed on a
mobile device
The Main window – displayed in LDC



