Page 184 of 192
Recommendations
Please note
The SMPS30 is only compatible with LA43 IC and the LA44 IC.
The SMPS30 is not suitable for outdoor applications
Before installation, re-installation or troubleshooting
• Stop the application
• Switch off the power supply and pull out the mains plug
• Relieve the application of any loads, which may be released during the work
Before start-up
• Make sure that the system has been installed as instructed in the User Manual
• System connection. The individual parts must be connected before the SMPS30 is connected to the mains.
During operation
• Ensure that the cables are not damaged
• Unplug the SMPS30 before moving the equipment
Device protection:
The SMPS30 contains several mechanisms to protect itself from being damaged due to excessive use.
• In case of overheating, the device will activate a thermal protection. No power output will be available until the temperature is back again within
normal operating range.
• In case of exceeding the current limit / failure in the actuator, the device will activate an overload protection. Immediately after the situation has
been remediated the power output will be available again.
Hot plugging
• It is not allowed to remove or to add the output cable as long as the SMPS is powered by mains.
Maintenance/cleaning
• The SMPS30 must be cleaned at regular intervals to remove dust and dirt and it must be inspected for mechanical damage, wear and breaks
• It is not allowed to spray directly with a high-pressure cleaner on the device
• Interconnecting cables must remain plugged in, correctly fitted with O-rings, during cleaning to prevent ingress of water
• The SMPS30 is resistant to the majority of cleaners and disinfectants used in the hospital and nursing home sector.
However, the detergents must comply with the following basic requirements
- They must not be highly alkaline or acidic (pH value 6-8)
- They must not contain caustic agents
The Under Bed Light (UBL) can be mounted under the bed to provide a discrete guiding
light when the patient leaves the bed during night. With an Under Bed Light it is easy to
switch the light on and off by means of a handset or controlling it automatically with the
Out of Bed functionality of the MJB8.
14. Under Bed Light (MEDLINE
®
CARELINE
®
)
Usage:
• Operating temperature: + 5 °C to + 40 °C
• Storage temperature: - 10 °C to + 50 °C
• Atmospheric pressure: 700 to 1060hPa
• Approvals: IEC 60601-1, ANSI/AAMI ES60601-1,
CAN/CSA-22.2 No 60601-1
• Connectivity: To be connected to MJB5 and MJB8
Recommendations
• The Under Bed Light (Item P/N.: 0964135) must be mounted on the bed with metal screws in order to maintain ESD protection.
To Next Page
Loading...
Need help?
General
