Page 11 of 192
Warnings
Failure to comply with these instructions may result in accidents involving serious personal injury.
• If there is visible damage on the product it should not be installed.
• If the actuator system makes unusual noise or smells, switch off the mains voltage immediately.
• The products must only be used in an environment that corresponds to their IP protection class.
• The cleaners and disinfectants must not be highly alkaline or acidic (pH value 6-8).
• Irrespectively of the load, the duty cycle stated on the product label must NOT be exceeded.
• The control box must only be connected to the voltage stated on the label.
• Systems not specified for pull must only be used in push applications.
• Fastening screws and bolts must be tightened correctly.
• Specifications on the product label must under no circumstances be exceeded.
• NOT TO BE OPENED BY UNAUTHORISED PERSONS.
• Only use the actuator within specified working limits.
• Be aware that during the design of medical devices, the risk of personal injury (for instance squeezing of fingers or arms) must be minimised.
• If irregularities are observed, the actuator must be replaced.
Generel assembly instructions
Please read the following safety information carefully. Ensure that all staff who are to connect, mount, or use the actuator system are in possession of
the necessary information and that they have access to these assembly instructions.
Persons who do not have the necessary experience or knowledge of the product/products should not use the product/products. Moreover, persons
with reduced physical or mental abilities must not use the product/products, unless they are under surveillance or they have been thoroughly
instructed in the use of the equipment by a person who is responsible for the safety of these persons. Moreover, children must be under surveillance
to ensure that they do not play with the product.
Failing to follow these instructions may result in actuator system damage:
• Prior to assembly/disassembly, ensure that the following points are observed:
- The actuator system is not in operation.
- The mains current supply is switched off and the plug has been pulled out.
- Actuators are free from loads that could be released during this work.
• Prior to operating the actuator system, check the following:
- Actuator system components are correctly mounted as indicated in the relevant user instructions.
- The equipment can be operated in its entire intended range of movement.
- Ensure that the load-supporting bolts can withstand the wear.
- Ensure that the load-supporting bolts are secured safely.
• During operation:
- Listen for unusual sounds and watch out for uneven movement. Stop the actuator system immediately if anything unusual is observed.
- Do not sideload the actuator.
- Do not step on or kick the actuator.
• When the equipment is not in use:
- Switch off the mains supply or pull out the plug in order to prevent unintentional operation.
• Note:
- When changing the cables on a LINAK actuator system, it is important that this is done carefully in order to protect the plugs and pins.
Please ensure that the plug is in the right location and properly inserted before the cable lid is mounted.
To Next Page
Loading...
Need help?
General
