Operation of the DPF4T “multiple references”
Function:
Compared to a standard DPF1C the first memory button on the DPF4T is replaced by a toggle button, i.e. that the panel has 2
memory buttons instead of 3 (memory 1 and memory 2).Besides the toggle button the DPF4T works like the DPF1C.
Up and down (
V):
You just either have to activate the up or down button for parallel drive and the system will drive until releasing the button
again or when the system reaches end position.
Memory:
The four small buttons are used for toggle function, memory drive and storing memory.
Store memory
• Press S – button, the display will flash for 2 seconds
• Within these two seconds press one of the small buttons with dots and the position will be stored at this
button 1A.
• The panel will acknowledge by showing “1”or “2” in the display depending on the chosen position
Memory drive (small buttons with dots)
Press one of the memory buttons and the system will start driving to the pre-programmed memory position.
Keep the button pressed until the position is reached.
Display function
Shows the actual height in either cm or inch.
= Parallel up
V = Parallel down
S = Store memory
= Toggle button
•• = Memory 1
•• = Memory 2
V
V
To Next Page
Loading...
Need help?
General
