Linak DPF1C

Page 31 of 44
Adjusting the clock
The clock is now activated.
1. Press the “clock button” using a ball pen.
24hr mode (European time mode) is default - can be changed to 12hr mode
(US time mode)
Changing time mode:
Press or
(Press the “clock button” again to confirm “time mode” using a ball pen)
2. Press or to adjust “hh”
3. Press the “clock button” again to confirm “hh”.
4. Press or to adjust “mm”
5. Press the clock button again to confirm “mm”
Display view:
Action:
Flashing
Flashing
hh is flashing
Switches to PM if hh > 11
mm is flashing
Example:
AM
PM
.
.
AM
.
PM
.
.
PM
.
.
PM
.
v
v
v
v
v
v
Troubleshooting (WDPL):
If errors occur the error code appears in the display - The “error” segment flashes (1 Hz).
E-02
E-03
E-01
Position lost
Initialise