Linak DPF1C User Manual

Page 32 of 44
Store a memory position
3 users can store 3 memory posistions each. The connected desks (max. 3) are to be adjusted individually - one at a time.
Quick setup:
On the back of the WDP you will find a quick guide for storing a memory position.
The position is now stored in the control box.
To store a new memory position on the same desk, go through points 3 to 6 again.
If the buttons are not activated for 15 sec., the clock function will appear in the display.
If only one desk is connected, - go to point 4.
1. Press
2. Press , or until the wanted desk is shown in the display.
3. Press
4. Press , or until the wanted user is shown in the display
5. Press or until the wanted height is obtained.
6. Press and then , or
Display view:
Action:
Flashing
Flashing
Example:
lll
ll
l
Store
v
v
lll
ll
l
User
lll
ll
l
Desk
Desk
I
User
I
Position
II
Store
Desk
I
User
I
Desk
I
User
I
Desk
I
User
I



Linak DPF1C Specifications

General

Brand	Linak
Model	DPF1C
Category	Controller
Language	English