Linde C200 - Limitations of Liability; 1.5 Copyright; Spare Parts; Warranty Provision

6/76
EN
1.4. LIMITATIONS OF LIABILITY
All of the information and notes in these instructions have been compiled in accordance with applicable
standards and regulations. They reflect best engineering practice and our years of experience.
The manufacturer accepts no liability for damages in the following instances:
• Failure to observe these instructions
• Utilization of the system for any other than the intended purpose
• Operation by untrained sta
• Unauthorized modifications
• Technical modifications
• Use of unlicensed spare parts
• Working with the gas supply panel when any safety device is broken or not functional mounted or safety
devices don’t work correctly
• Improper control of components, connections and gaskets, which are wearing parts.
• Incorrect reparations
• Violation of temperature limits, which are dedicated in the datasheet during operation or storage
• In case of disaster or force majeure
The actual scope of supply may dier from the explanations and illustrations in these instructions following
the incorporation of new technical changes. The obligations stipulated in the supply agreement, our general
terms and conditions of business, the manufacturer’s terms and conditions of supply and the statutory regula-
tions in force at the time of contract conclusion apply.
1.5. COPYRIGHT
The contents of these instructions are protected by copyright. They may be used in connection with the
operation of the system. Any other use above and beyond the aforementioned is only permitted with the
written consent of the manufacturer.
1.6. SPARE PARTS
WARNING!
• Risk of injury from using incorrect spare parts!
• The use of incorrect or defective spare parts can result in risks for the operating sta and in damages,
malfunctions or total failure of the system.
• Only use original spare parts from the manufacturer or spare parts authorized by the manufacturer.
• Always consult the manufacturer if in doubt.
LOSS OF WARRANTY
• The manufacturer’s warranty lapses if unauthorized spare parts are used.
1.7. WARRANTY PROVISION
In principle, our "General Terms and Conditions of Sale and Delivery" shall apply.
These are available to the customer at the latest since the conclusion of the contract.
1.8. CUSTOMER SERVICE
Please do not hesitate to provide us with information and experiences gained through use; we welcome any
valuable input that will help to improve our products.
2. SAFETY
This section provides an overview of all the important safety aspects to ensure the protection of your sta
and the safe and trouble-free operation of the equipment. Further safety information relating to specific tasks
can be found in the sections on the individual life cycle phases.
2.1. INTENDED USE
The cylinder regulator C300, C200 and C60 are only usable for the defined standard gases and pressures
observing the given temperature range. The nominal flow is according to ISO 2503 20 m/h (Air). Intended
use also includes compliance with all the information in these instructions and compliance with reparation,
maintenance working, type label and data sheets. Any use other than, or above and beyond, the intended
use constitutes improper use.